No-Slip
No-Slip is a micronized polymer (finely ground) Slip Resistant Additive that has been designed specifically
for use in GST film forming sealers, which include: all Wet Look Lacquers, Lock ‘N Seal and Satin Seal.
No-Slip provides a comfortable walking surface for bare feet and will not dissolve in solvents,
absorb oil or expand in water.
GST
International
Global Sealer
Technologies
• GST’s No-Slip must be applied using a low pressure pump sprayer.
•To ensure even application of No-Slip, continuous agitation while spraying
is required.
• Using a brush or roller will cause uneven distribution of No-Slip additive,
resulting in slippery areas.
•When applying No-Slip to pool coping, use an overspray paint shield to
avoid getting sealer in the pool. Be sure to clean paint shield often to avoid
excess sealer/No-Slip contaminating the pool water.
•No-Slip cannot be used with penetrating sealers and must be used with
film forming sealers.
product Description:
For Newly Poured Concrete
Use ConCure immediately after new concrete is poured. Allow approximately
28 days for new concrete to cure prior to applying any GST Sealer.
Where Efflorescence, Rust or Cement Scale is Present
Use Clean Concrete to remove efflorescence, rust and cement staining.
Where Cleaning is Needed or Efflorescence Remover Has Been Used
Use Pro-Grade Cleaner to thoroughly clean, remove oil, grease, dirt and prepare
the surface prior to applying any of the GST Sealers.
Use ProGrade Cleaner to neutralize pH where Clean Concrete was used.
Choose an Invisible or Appearance Enhancing Sealer
To be applied after the surface is clean and dry.
Choose an Appearance Enhancing Sealer: Choose an Invisible Sealer:
• Low Sheen Wet Look Lacquer • Water Block
• High Gloss Wet Look Lacquer • Stain Block Elite
• Lock ‘N Seal
• Satin Seal
• Stone Enhance
• Final Coat
